Building A Pony Wall On The Floor

Another method is to run the half wall 4 4 outer post down into the framing and to bolt it to a joist or similar blocking and use 2 1 2 through bolts to attach 4 4.
Building a pony wall on the floor. One method that works extremely well if the floor joists and half wall line up to install 1 2 plywood over the wall and down past the subfloor and onto the floor joist. Repeat at the other end of the board. If it s not use shims to level it out. Use a hammer drill with 3 16 masonry bit to drill a hole through the wood and into the concrete floor.
Once the frame is aligned attach it to the wall and the floor using 3 1 2 inch screws. The term pony wall is used to refer to a load bearing wall that rests on the sill plate of a foundation and supports the joists of the floor above it. Make sure the frame is plumb and square then attach it to the floor and adjoining wall. Nailing or screwing the last stud in the pony wall to studs or blocking in the intersecting wall braces that end well.
These walls are sometimes called cripple walls and they carry the load of the entire structure and transmit it to the foundation. Cut pressure treated 2 x 4 boards to length and lay them along the chalk line. Another part of our video history of the house build. Add another beam to the top of the pony wall and make sure it s level.
Paint the wall then finish it out with trim. Cover the wall using drywall or half inch medium density fiberboard mdf. Use an impact driver to drive a 3 tapcon screw through the wood and into the floor. Technically the first floor walls of a multi story building are.
This is easy when the pony wall meets a perpendicular wall.