Blind Nailing Hardwood Floor By Hand

The process of blind nailing.

Blind nailing hardwood floor by hand. The nails secure the boards to the floor wedging them together at the same time. Flooring nails have special qualities that make them suitable for the job. Before flooring installers had power nailers they had to blind nail all flooring boards by hand. The second method called toe nailing or blind nailing involves driving the nails through the tongues of the flooring boards at an angle.

Solid hardwood flooring only can be installed on or above ground level with a plywood subfloor. Be sure to countersink the nail drive it slightly below the surface of the wood to prevent interference in the. Engineered flooring can be installed above grade at grade and below grade level do not install hardwood flooring in bathrooms. In olden times blind nailing was done with a hammer to start the nail then as a woodworker got close to the wood a nailset was used with the hammer to countersink the.

There is really vey little room to swing a nailer hammer since i ll probably lay the first row in the middle of the hall and work towards both walls. I am also laying it parallel to the joists on 3 4 plywood subfloor that is in good conditon. To face nail a board you simply drive a nail through its face into the sub floor. For tongue and groove flooring drive a nail at a 45 degree angle through the tongue then conceal it by engaging the groove of the next board.

Blind nailing is a method of concealing a nail using the adjacent installed board. Blind nailing is setting a nail into the hardwood flooring board at a 45 degree angle just above the tongue of the board and driven down into the joist or subfloor surface. I am putting 2 1 2 x 3 4 hardwood flooring in a hall that is about 36 wide. The process involves driving a series of nails into the tongue of a.