Blind Nail Hardwood Floor

Blind nailing is a method of concealing a nail using the adjacent installed board.

Blind nail hardwood floor. Installing solid hardwood floors the guy at the big box store only had flooring nails. Blind nail glue. This size allows the nail to pass through both the walking floor and the plywood and leaves 1 inches of nail to secure to the joists. Engineered flooring can be installed above grade at grade and below grade level do not install hardwood flooring in bathrooms.

Blind nailing is setting a nail into the hardwood flooring board at a 45 degree angle just above the tongue of the board and driven down into the joist or subfloor surface. The process of blind nailing. A one eighth inch depth is enough. Pre sanding the floor to allow for a nail head at floor level or slightly above is another option.

When nailing the final courses do so by blind nailing or nailing into the groove at a 45 degree angle. Support see jane drill by. Hosking hardwood recommends an 8 penny nail which is roughly the equivalent of a 3 inch nail. Before flooring installers had power nailers they had to blind nail all flooring boards by hand.

The process involves driving a series of nails into the tongue of a. Flooring nails have special qualities that make them suitable for the job. Solid hardwood flooring only can be installed on or above ground level with a plywood subfloor. Then the cut nail can be hammered in as part of the finish process.

For tongue and groove flooring drive a nail at a 45 degree angle through the tongue then conceal it by engaging the groove of the next board. The humble nail has a long history of craftsmanship behind every bag or box. To do this the floor must first be secured with blind nailing or glue and sanded. Always check with the manufacturer s instructions to determine if your hardwood floor can be installed over an in floor radiant heat system.

Countersink the nail to avoid shaving off the decorative head. Be sure to countersink the nail drive it slightly below the surface of the wood to prevent interference in the. In olden times blind nailing was done with a hammer to start the nail then as a woodworker got close to the wood a nailset was used with the hammer to countersink the. At one point it will be necessary to top nail the last few rows.

Types of nails for laying hardwood floor.